To satisfy the import requirements of those countries, the `npe' universal image does not support any strong payload encryption Just new to cisco wireless controller Please follow these instructions from my buddy @jim leko on how to manually import them into cml and you should be good to go
#K9SelfieSunday 📸: @k9socialbutterfly... - Female K9 Handlers
It will help newbies (like me) for the correct filename and thus save time if the vpn documentation is updated.
I'm new to this group and not very well versed yet in cisco wireless equipment
I'm actually working on my ccna for routing/switching right now Someone offered me a couple of wireless ap's that they had no use for, so i figured it couldn't hurt to get in some practice with wireless However i've run into a slight issue I can't get them to reset to factory settings
Multipoint treat as a multipoint link. Cisco cisco2911/k9 (revision 1.0) with 483328k/40960k bytes of memory Processor board id fgl201011k6 2 fastethernet interfaces 3 gigabit ethernet interfaces 1 terminal line dram configuration is 64 bits wide with parity enabled 255488k bytes of ata system compactflash 0 (read/write) license info:
Hi, we having a scenario where we have two ssid on the same vlan, so the questions is how to force the cisco ap to use one ssid not the other because we trying to remove the 2nd ssid
Can anyone explain to me how the cisco ap pick an ssid i think it's based on the vlan but what's the case if there are two ssid with one vlan
